The enhanced functions offer many advantages including:. Access to printhead, platen, paper path, and sensors is improved by the development of new wide opening mechanism. These machines are unique in the market. Pharmaceutical Industry. Electronics Industry. The BCI can run Basic programs allowing the manipulation of incoming print data to generate the correct label formats. This allows the printer to be connected to existing legacy systems eliminating the need for costly software changes.
Easy access to printhead, platen, paper path and sensors. Make sure that the printer Power Switch is turned to the OFF position before connecting the Power Cord to prevent possible electric shock or damage to the printer.
Use only the Power Cord supplied with the printer. Do not turn the Locking Ring counter-clockwise too far or it may come off the Supply Holder. Page 17 2. Put the media on the Supply Shaft. Pass the media around the Damper, then pull the media towards the front of the printer. Align the projection of the Supply Holder with the groove of the Supply Shaft, and push the Supply Holder against the media until the media is held firmly in place.
Page 18 2. NOTE: Be sure to set the black mark sensor to detect the centre of the black mark, otherwise a paper jam or no paper error may occur. Lower the Print Head Block until it stops. Page 19 2. NOTES: 1. Page 20 2. Page 21 2. The cutter is sharp, so care must be taken not to injure yourself when handling the cutter. Be sure to cut the backing paper of the label. Cutting labels will cause the glue to stick to the cutter which may affect the cutter quality and Page Loading The Ribbon 2.
Do not touch any moving parts. To reduce the risk of fingers, jewellery, clothing, etc. Page 23 When the auto ribbon saving function is selected, it will be activated to reduce ribbon loss when a no print area extends more than 20 mm. Page Test Print 2. Select the sensor type which matches the media being used. Select the print mode which matches the media being used. Page 26 2. Page 27 2. Page 28 2. Sample of the factory test label E Page On Line Mode 3.
This chapter describes usage of the keys on the Operation Panel in On Line mode. Page Operation 3. However, when a communication error or command error occurs, the printer returns to an idle condition.
Page Dump Mode In Dump mode, any characters sent from the host computer will be printed. Received characters are expressed in hexadecimal values. This allows the user to verify programming commands and debug the program. Page Maintenance 4. Be sure to disconnect the power cord before performing maintenance. Failure to do this may cause an electric shock. To avoid injury, be careful not to pinch your fingers while opening or closing the cover and print head block.
Page Covers And Panels 4. Page Optional Cutter Module 4. Be sure to turn the power off before cleaning the Cutter Module. As the cutter blade is sharp, care should be taken not to injure yourself when cleaning. Be sure to carefully review Page Troubleshooting This chapter lists the error messages, possible problems, and their solutions.
If a problem cannot be solved by taking the actions described in this chapter, do not attempt to repair the printer. Page Possible Problems Remove the ribbon, and check the status of the ribbon. Replace the ribbon, if necessary.
Load a new ribbon. This section describes in detail how to remove jammed media from the printer. To maintain a constant print position the printer uses the Transmissive Sensor to detect the gap between labels by measuring the amount of light passing through the media.
Page A1. There are restrictions in use of the media which is narrower than 50 mm. The warranty does not apply to any problem caused by using non-approved ribbons. Symbols in the message : The LED is illuminated.
Keep as short as possible.
0コメント